magic_racoon
09-05-2010, 07:27 PM
hey guys just looking for a little advice
ive just finished makeing 3 individual wolverine claws and im looking to make a silicone mould and then start casting them in resin
the claws are made from wood my questions are
what is the best way to mould them because there so thin as they get closer to the tip a two part cast or an all in one cast i would tend to favour an all in one cast but would they slip free from the mould without damage?
ive watched some you tube to learn casting as im quite new to it all
any tips from you guys would be great i know its not sculpting persay but i did sculpt it from wood so its a technicality here :P
ive just finished makeing 3 individual wolverine claws and im looking to make a silicone mould and then start casting them in resin
the claws are made from wood my questions are
what is the best way to mould them because there so thin as they get closer to the tip a two part cast or an all in one cast i would tend to favour an all in one cast but would they slip free from the mould without damage?
ive watched some you tube to learn casting as im quite new to it all
any tips from you guys would be great i know its not sculpting persay but i did sculpt it from wood so its a technicality here :P