Kerrigan Sideshow Statue Right Wings won't stay in the front hole

[Makutsu]

Hey, just recently purchased a Kerrigan off ebay, and I found that the right wing won't stay in the front hole, I think the pin might be too short or the PVC wing just isn't bent enough for it, anybody have any solutions?

[Nugchompa]

I remember having to bend mine more than I felt comfortable with.

[Makutsu]

I remember having to bend mine more than I felt comfortable with.

I've gotten past the bending part, it just won't stay in the hole, it just pops back out, I think the pin is too short or something?

[Y3E]

Is the pin attached to a peg that also goes in the hole? If so, put some tape around the peg to make it more snug. Do one layer at a time until it works.

[Makutsu]

Is the pin attached to a peg that also goes in the hole? If so, put some tape around the peg to make it more snug. Do one layer at a time until it works.

That actually sounds like a good idea, i'll give it a whirl tonight :D

[Makutsu]

Seems like the angle of the pin and the hole angle is different somehow :/

[Nugchompa]

Pictures?

[Makutsu]

Pictures?

I fixed it now with some greenstuff re-angling the hole in the correct direction so it stays in now, thanks all! :D