Thor Premium Format Figure (2022)

[Divo]

Originally Posted by ob1ob

Thank you for the advice. I think I may have lucked out as after installing and removing Thor from the base a few times, the foot is almost completely flush. The inside of the foot is flush and the very small gap on the outside isn?t really noticeable.

I knew you wouldn't need much, but an old fashioned stare-down is all it took? Whatever works, as it was imperative to get that foot coming down, crushing that giant's skull, showcasing the regal power of a thunder god.

Nice.

[ob1ob]

Originally Posted by Divo

I knew you wouldn't need much, but an old fashioned stare-down is all it took? Whatever works, as it was imperative to get that foot coming down, crushing that giant's skull, showcasing the regal power of a thunder god.

Nice.

“an old fashioned stare-down”
I don’t know if there was some extra material that was removed from my sliding the peg/key in and out of the base or if I just didn’t have it seated properly. It’s still not perfect but a big improvement from the very noticeable gap before.

[Divo]

Originally Posted by ob1ob

?an old fashioned stare-down?
I don?t know if there was some extra material that was removed from my sliding the peg/key in and out of the base or if I just didn?t have it seated properly. It?s still not perfect but a big improvement from the very noticeable gap before.

If mine, too close to an easy fix to leave Thor "hanging" like this. I suggest using more of that heat-vision, or thunderbolts cause you're close. Whatever it takes get that foot to sit, because that skull crush is a buzz!