Prime 1 Robotech Rick Hunter Officers Battleoid statue

[craigcliff1]

They did this one in new scale

[myskye23]

Originally Posted by craigcliff1

They did this one in new scale

.. Nice to see Prime 1 didn't drop this completely. I was planning on picking up the Officer's Battleoid they had on display but then they never put it up for PO. This is a nice alternate addition.

[Mooste]

So it is in the same scale as the Skull Leader?

[craigcliff1]

Yes.

[Phoenixblazes]

Originally Posted by Mooste

So it is in the same scale as the Skull Leader?

Originally Posted by craigcliff1

Yes.

Yes, but what’s the ‘actual’ height for the Skull Leader piece?!



As both the Skull Leader and the new EVA-01 are listed as being 67cm!?

And looking at that photo I’m assuming the EVA is correct, and the Skull Leader piece is actually a lot smaller than I thought it was.....no wonder why it was so much cheaper.

So I’m guessing it’s somewhere around 50cm in height.

[craigcliff1]

about 27 inches. with the base and fast pack I would put the Battleoid itself at about 20 inches.

[Phoenixblazes]

Originally Posted by craigcliff1

about 27 inches. with the base and fast pack I would put the Battleoid itself at about 20 inches.

I seriously doubt it.

The EVA is 27”, and the Death Stranding piece is likely to be around 42” (like the other one released in the line).

Unless Prime 1 are producing the exact same sculpt in two different scales......which I also doubt.

[craigcliff1]

Yes I notice it now from that photo. Could be a new scale again

[Phoenixblazes]

It’s been confirmed that the Skull Leader dimensions are incorrect and should in fact be as follows: H:52.4cm W:29.2cm D:37.5cm (H:20.6" W:11.5" D:14.8")

[Mooste]

That is a lot smaller....