Little teaser from Lady Mechanika.
It's going to be big
The details are incredible
I spent hours preparing for the print.
Since I print these parts hollow, i have to make sure that everything is properly supported.
And i have to be careful that there are no places where liquid resin remains. Like these three pockets.
That's why I made two holes on the bottom of each pocket so that the resin can drain.
If the resin stays in such pockets, it develops gas and at some point it explodes with a loud bang.
I probably didn't put enough supporters on the head because part of the hair wasn't printed.
I then set the missing supporters and printed the head again.
With the same result ??? I just lack some experience.
I have now sculpted the missing hair. Everything still looks a bit raw, but that's fine until it's finished